Open side-bar Menu

Archive for the ‘3dS Max’ Category

Villa R 05 in Eze, France by 2&1

Tuesday, June 4th, 2013

Article source: 2&1

Construction of 2 twins villas on the hills of Eze ( near Monaco ), FRANCE.
There are 4 levels of each villa :

  • Lvl1 : Private garage ( common for both villas )
  • Lvl2 : Bedrooms ( and private bathroom )
  • Lvl3 : Open space with living room / dining room / kitchen and the \”wc block\” ( partition wall in wood )
  • Lvl4 : Roof top with summer kitchen

The interior design is minimalist in order to enhance the structural elements.

Image courtesy 2&1

  • Architects: 2&1
  • Project: Villa R 05
  • Location: Eze, France
  • Schedule: Work in progress – 2013
  • Area: 1900m² – 660m² habitable
  • Software used: For plans, Autocad, and for 3d, it’s 3ds Max with Vray

House of Mr. R in Moscow, Russia by za bor Architects

Friday, May 31st, 2013

Article source: za bor Architects

The house has solid-cast reinforced concrete frame with piers and bridging and walls made of brick. One wall is sloped (hacking brickwork). There are two apartment floors and a basement storey deepened to 1,20 meters below ground level (the only thing deeper is a wine cellar). The services: water pumps, blowing wells, an emergency diesel-generator and a fuel storage tank are located in the basement storey. A sanitary piping, gas and electricity supply are also arranged in the basement.

Image Courtesy © Zinur Razutdinov and Peter Zaytsev

  • Architects: za bor Architects
  • Project: House of Mr. R
  • Location: Moscow, Russia
  • Photography: Zinur Razutdinov and Peter Zaytsev 
  • Firm principle or leading designers: Peter Zaytsev and Arseniy Borisenko 
  • Built area: 300 square meters (560 sq m floor area
  • Walls outside: plaster and exterior house paint, paving tiles
  • Walls inside: gres, wooden panels (wenge, oak), paint
  • Flooring: gres, marble, river pebbles (decorative covering), glass, wooden floor (oak)
  • Ceiling: paint
  • Software used: ArchiCAD, 3Ds Max, Photoshop


HDJ58 house in Tijuana, Mexico by T38studio + Pablo Casals-Aguirre

Thursday, May 30th, 2013

Article source: T38studio + Pablo Casals-Aguirre

Single family house in Tijuana, on a site where we are developing ten other single family infill houses on sites that range from 300 sq m to 450 sq m.

Image Courtesy © Alfredo Zertuche

  • Architects: T38studio + Pablo Casals-Aguirre
  • Project: HDJ58 house
  • Location: Tijuana, Mexico, Baja California
  • Photography: Pablo Casals-Aguirre, Alfredo Zertuche
  • Project Team: Alfonso Medina, Pablo Casals-Aguirre, Lucía Arroyo
  • Collaborators: Oscar González, Sara Díaz, Ana Darice Payan
  • Construction: Taller38
  • Project Year: 2011
  • Site surface: 330 m2
  • Built surface: 300 m2
  • Software used: Autocad, skethcup, 3dstudio, photoshop and Illustrator.


Coffee House chain by Amerikka Design Office Ltd

Thursday, May 23rd, 2013

Article source: Amerikka Design Office Ltd

Coffee House chain: Space planning delivers extra kick to both brand and sales. The cooperation of Amerikka Design Office Ltd. and SOK’s Coffee House café chain began in spring 2011 and the first completed locations are being opened to the public in October and November 2011. In addition to an increase in customer seating and sales, emphasis has been put on space concept development work for Coffee House recognition as well as on the chain’s distinctive character and visibility.

Image courtesy Amerikka Design Office Ltd 

Vertical Zoo in Buenos Aires, Argentina

Tuesday, May 21st, 2013

Article source: Sergio Villegas

The Project is located in one of the lakes of the reserve due to the lakes keep changing over the course of the seasons; this factor makes them the most dynamic points of the reserve. The Project looks for accentuate the reserve formation process. The proposal emerges from the mixture between the existing ecosystem of the place and the elements that characterized the harbor landscape like containers, cranes, structures and colors.

Image Courtesy Sergio Villegas

  • Architects: Occlusion studio
  • Project: Vertical Zoo
  • Location: Buenos Aires, Argentina
  • Team: Sergio Villegas, Alejandro Corrales, Natalia Cuartas
  • Project Completion Date: 2009
  • Project Type: Institutional
  • Project Site Context/Setting: Urban/Landscaping
  • Building Gross Floor Area: 2.000 square feet
  • Other Building Description: International Contest
  • Software used: Sketchup, 3Dmax, Vray, Photoshop, After Effects


ZENSE: The Rebirth in Bangkok, Thailand by Department of Architecture

Wednesday, May 15th, 2013

Article source: Department of Architecture

During2010 Red Shirt Riot, many of Bangkok’s public buildings were set on fire.  Podium of ZEN Tower in Central World Complex was totally unrecognizable.  Smoke and heat went upward and destroy all furniture and finishing of all interior space on the tower.  ZENSE, thena newly-opened yet one of the hippest Restaurants/Bars in the city, situated on ZEN Tower top floor, was one of the casualties of this unrest.  As the original designer, DEPT was called to give ZENSE another life after the riot.

Image Courtesy © KetsireeWongwan 

  • Architects: Department of Architecture
  • Project: ZENSE: The Rebirth
  • Location: Centralworld Shopping Complex, Pathumwan, Bangkok, Thailand
  • Photography: KetsireeWongwan
  • Owner: Zen Department Store
  • Lighting Designer: Accent Studio
  • Area: 4,000 m2
  • Cost of the construction: 80 Million THB
  • Build time: 2011-2012
  • Software used: Rhino 3D, 3D Studio Max and AutoCAD

The National Library in Jerusalem, Israel by Baer, Shifman-Nathan Architects

Sunday, May 12th, 2013

Article source: Baer, Shifman-Nathan Architects

The new Master Plan for the Ben-Gurion Campus 101-0661176, clearly marks a conceptual shift which is intended to gradually transform Rupin Road into the main axis of the Government Compound of Giv’at Ram. This new vision radically transforms the approach of scattering architectural landmark buildings within a large urban “park”, so as to create a vibrant urban fabric.

Image courtesy Baer, Shifman-Nathan Architects 

  • Architects: Baer, Shifman-Nathan Architects
  • Project: The National Library
  • Location: Jerusalem, Israel
  • Photography: Baer, Shifman-Nathan Architects
  • Area: 45,000 m2
  • Client: The National Library
  • Software used: AutoCAD and 3dS Max

The Slabs – Italian Pavilion Expo 2015 in Milan, Italy by MenoMenoPiu Architects + BE.ST Architect

Saturday, May 11th, 2013

Article source: MenoMenoPiu Architects + BE.ST Architect

Our proposal for the Italian Pavilion at the Milan 2015 Expo is a light cage where the technical innovation is embedded within the structure: revolutionary glass columns sustain traditional  slabs clad in marble. The building is simple and elegant in its structural system. Marble and glass are intertwined expressing the Italian architectural tradition of proportion and elegance.

Nature makes its way through the thin marble: tress are allowed to grow tall through holes in the slabs, recalling the central role of nature in a healthy feeding culture. These holes let the light from above reach the ground level where the covered plaza stands. The latter is trimmed by a thin water layer which creates small “islands” and a mirror-like surface. Water and shadow cool down the temperature of the plaza so offering a shelter from the sunny space before the circular pond at the end of the Cardo.

Image courtesy MenoMenoPiu Architects + BE.ST Architect 

  • Architects: MenoMenoPiu Architects + BE.ST Architect
  • Project: The Slabs – Italian Pavilion Expo 2015
  • Location: Milan, Italy
  • Project Team: MenoMenoPiu Architects – Rocco Valantines, Mario Emanuele Salini, Marco Lavit Nicora, Paolo Carignano, Alessandro Balducci
  • Project Team: BE.ST Architect – Stefano Belingardi Clusoni
  • Software used: 

    2d Autocad
    3d Rhinoceros
    Rendering 3ds max
    Post Production Photoshop

Newark Visitor’s Center in Newark, New Jersey by Baer, Shifman-Nathan Architects

Wednesday, May 8th, 2013

Article source: Baer, Shifman-Nathan Architects

Designing the Newark Visitor’s Center meant bridging between opposing forces. On the one hand, there was a need to address the adjacency to the metropolitan center of NYC and its main transportation Hub – the Penn Station. This perspective implied the creation of a vibrant architectural event, which is capable of containing the centrality of Newark and of the reality of New Jersey as one of the most populated states in the US. On the other hand, there was a strong pull to blend with an image of a Garden State, or at least create a gateway to suburban America, which is perceived as a place of refuge, away from the metropolitan intensity.

Image Courtesy Baer, Shifman-Nathan Architects

  • Architects: Baer, Shifman-Nathan Architects
  • Project: Newark Visitor’s Center
  • Location: Newark, New Jersey
  • Area: 1,800 m2
  • Client: The City of Newark
  • Software used: Designed with AutoCAD, images were constructed with 3D max + rendering


Dean of Students’ Building in Be’er Sheba, Israel by YBGSNA

Wednesday, May 8th, 2013

Article source: YBGSNA

The Dean of Students’ Building functions as the academic and social hub of the School of Engineering in Be’er Sheba University. Its modest program is structured around a terraced three story public space of the different departments.  It is designed in exposed concrete in relationship to the old concrete campus of the 50’s to match the modern Architectural language of the School of Mechanical Engineering Complex.

Image Courtesy © Ilia Kruvorechko

  • Architects: YBGSNA
  • Project: Dean of Students’ Building
  • Location: Be’er Sheba, Israel
  • Photography: Ilia Kruvorechko
  • Area: 600 m2
  • Cost: $3,500,000
  • Client: Ben Gurion University
  • Design: Baer, Shifaman-Nathan Architects
  • HVAC: HRVAC Engineers
  • Plumbing: A. Schwartz Ltd
  • Structural Engineer: S. Angel Ltd
  • Software used: Designed with AutoCAD, images were constructed with 3D max + rendering


GRAPHISOFT: ARCHICAD download 30-day FREE trial
Graphisoft ARCHICAD  Download a 30-Day FREE trial
TurboCAD pro : Start at $299 - Countless CAD add-ons, plug-ins and more.

Internet Business Systems © 2016 Internet Business Systems, Inc.
595 Millich Dr., Suite 216, Campbell, CA 95008
+1 (408)-337-6870 — Contact Us, or visit our other sites:
TechJobsCafe - Technical Jobs and Resumes EDACafe - Electronic Design Automation GISCafe - Geographical Information Services  MCADCafe - Mechanical Design and Engineering ShareCG - Share Computer Graphic (CG) Animation, 3D Art and 3D Models
  Privacy Policy