Logic Design for Array-Based Circuits

Copyright © 1996, 2001, 2002 Donnamaie E. White

• Table of Contents
  
• Preface
  
• Overview
  
• Chapter 1 Introduction
• Chapter 2 Structured Design Methodology
• Chapter 3 Sizing the Design
  • Functional Specification - A Closer Look
  • Review the Available Arrays
  • Architectual Specification or Hardware Specification
  • Array Sizing
  • Cell Capabilities
  • Array Architecture
  • Netlist
  • Example: AMCC Interface Options
  • Example - AMCC Arrays - Power Supply Options
  • Interface Cell Functionality
  • Examples
  • Internal Cell Functionality
  • Multi-Cell Macros
  • Hard and soft macros
  • Refining Interface Requirements
  • Adding Extra Power and Ground Macros
  • Dual-Function I/O Macros
  • Example - Simultaneously Switching Outputs
  • Thermal Diodes
  • The AMCC Speed Monitor
  • Final Interface Cell Utilization
  • Drivers
  • Exercises
• Chapter 3 Appendix: Case Study in Sizing a Design
  • Target Array: AMCC Q20080 (1994 Data)
  • Solution - Q20000
  • Selecting a Flip/Flop - First Pass
  • Selecting the ECL Output
  • Clock Input
  • 16:1 MUX
  • Parity Tree
  • Review Status so far
  • Exercise
  • Simultaneouly Switching Outputs
  • Fanout Loads
    • Select Lines for 16:1 MUX
    • Reset Loading
    • Clock
    • Static Driver
  • Review of Size - Second Pass
  • Package Size
  • Problems
  • Alternative Solution
  • Power
  • Further Thought
  • The Schematics
• Chapter 4 Design Optimization
• Chapter 5 Timing Analysis for Arrays
• Chapter 6 External Set-up and Hold Times
• Chapter 7 Power Considerations
• Case Study: DC Power Computation
• Case Study: AC Power Computation
• Chapter 8 Simulation
• Case Study: Simulation
• Chapter 9 Faults and Fault Detection
• Chapter 10 Design Submission
• ASIC Glossary
  • Glossary A-D
  • Glossary E-K
  • Glossary L-R
  • Glossary S-Z
  • Symbols

Case Study: Sizing A Design

Last Edit July 22, 2001

16:1 MUX

The 16:1 MUX is constructed from five MX21S macros, each a 4:1 MUX with two selects. This is the largest multiplexor in the first release. Four of these will feed into the fifth to form the 16:1 MUX structure. Since there are two 16:1 MUXs, there will be 10 MX21S macros required. An 8:1 or 16:1 MUX MSI macro would simplify the design. The basic design is shown in Figure A-7.

Figure A-7 Schematic Page for the 16:1 MUX

Copyright @ 2001, 2002 Donnamaie E. White, White Enterprises
For problems or questions on these pages, contact dew@Donnamaie.com